Spa Choice Sanitizing Granules
Spa Choice Sanitizing Granules are designed to dissolve quickly and completely. Chlorine granules provide a steady source of available chlorine to spa water to control algae growth, kill bacteria and destroy organic contaminants. Spa choice chlorine granules are stabilized to protect against ultraviolet radiation from the sun, increasing the life of your chlorine.
DIRECTIONS FOR USE
PRECAUTIONARY STATEMENTS
It is a violation of federal law to use this product in a manner inconsistent with its labeling. This product is designed to dissolve quickly and completely providing a steady source of available chlorine to control the growth of algae, kill bacteria and destroy organic contaminants.
READ THE PRECAUTIONARY STATEMENTS BEFORE USE:
METHOD OF APPLICATION: Broadcast the product evenly over a wide area in the deepest part of the spa with water
circulating.
SPA AND HOT TUB USE: Each level teaspoon (0.17 ounces) of this product will provide epproximately 1.4 ppm available chlorine in 500 gallons of water. Using an appropriate test kit, test and adjust the water to the following values: pH 7.2-7.8, total alkalinity 60-100 ppm, calcium hardness 200 ppm minimum. Maintain these conditions for proper spa and hot tub operation by frequent testing with a test kit. Do not allow cyanuric acid level to exceed 150 ppm. Its recommended that spas and hot tubs be drained every 30-90 days. More often under heavy use. Consult manufscturer’s recommendations conceming the compatibility of chlorine sanitizers with their equipment. Some oils, lotions, fragrances and cleaners may cause foaming or cloudy water and may react with chlorine sanitizers to reduce their efficacy.
START-UP (FRESHLY FILLED)
1. Turn on the circulation system and ensure that it is operating properly.
2. Add 6 teaspoons of this product for each 500 gallons of water.
Check the free available chlorine (FAC) and, if below 4-5 ppm, repeat as needed. Re-entry into tested spas is prohibited above levels of 3 ppm of chlorine.
REGULAR USE: Turn on the circulation system and ensure that it is operating properly. Scatter approximately 3 teaspoons per 500 gallons of this product over the surface of water. Always use a clean dry spoon. Test for FAC end add additional product, if
necessary, to attain 4-5 ppm FAC. Maintain 1-3 ppm FAC while the spa or hot tub is in use. After each use, shock treat with
9 teaspoons per 500 gallons water to control odors and algae. Repeat as needed. Re-entry into treated spas is prohibited
above levels of 3 ppm of chlorine.